The use of heat to repair damage is not recommended for this classification of steel.
Recommended Repairs
Cold repairs can be performed on this type of steel, unless the damage includes kinks. If the
damage includes kinks, the part should be replaced.
Sectioning or partial replacement of this type of steel is recommended only at approved locations,
in a specific sectioning procedure.
When recommended in a specific sectioning procedure, this type of steel can be used as a weld
plate for reinforcing the sectioning location.
Squeeze Resistance Spot Welding can be used to replace factory spot welds, where applicable.
MIG plug welding and MIG stitch welding can be used on this type of steel.
MIG Brazing can be used on this type of steel.
Welds mentioned in text and shown in graphics are accurate at the time of publication. Use
vehicle being repaired for accurate count and location. If count and location of welds cannot be
determined, use information provided in Service procedure.