Skip to content
Tahoe / Yukon Service Manual

DTC C0001-C0004, C0010, C0011, C0014, C0015, C0018, C0019, C001C, or C001D

DTC C0001-C0004, C0010, C0011, C0014, C0015, C0018, C0019, C001C, or C001D Diagnostic Instructions Perform the Diagnostic System Check prior to using this diagnostic procedure: Diagnostic System Check - Vehicle Review the description of Strategy Based Diagnosis: Strategy Based Diagnosis An overview of each diagnostic category can be found here: Diagnostic Procedure Instructions DTC Descriptor DTC C0001 Brake Master Cylinder Separating Solenoid Valve 1 DTC C0002 Brake System Plunger Separating Solenoid Valve 1 DTC C0003 Brake Master Cylinder Separating Solenoid Valve 2 DTC C0004 Brake System Plunger Separating Solenoid Valve 2 DTC C0010 Left Front Inlet Solenoid Valve DTC C0011 Left Front Outlet Solenoid Valve DTC C0014 Right Front Inlet Solenoid Valve DTC C0015 Right Front Outlet Solenoid Valve DTC C0018 Left Rear Inlet Solenoid Valve DTC C0019 Left Rear Outlet Solenoid Valve DTC C001C Right Rear Inlet Solenoid Valve DTC C001D Right Rear Outlet Solenoid Valve Symptom Byte Information: Symptom Byte List Circuit/System Description For an overview of the component/system, refer to: ABS Description and Operation Conditions for Running the DTC Ignition/Vehicle = ON Conditions for Setting the DTC K160 Brake System Control Module = Internal Malfunction K160 Brake System Control Module = Greater than 265°C (509°F) Actions Taken When the DTC Sets Brake warning indicator malfunction. = ON ABS Warning Indicator = ON Traction/Stability Control Indicator = ON Hill Descent Control = ON Vehicle Speed Limit = Less than 100 km/h (62 MPH) Brake Assist = None Malfunction Indicator Lamp (MIL) = ON DTCs listed in the DTC Descriptor category = Type A DTC Conditions for Clearing the DTC DTCs listed in the DTC Descriptor category = Type A DTC Reference Information DTC Type Reference Powertrain Diagnostic Trouble Code (DTC) Type Definitions Schematic Reference Antilock Brake System Schematics Connector End View Reference Master Electrical Component List Electrical Information Reference Circuit Testing Connector Repairs Testing for Intermittent Conditions and Poor Connections Wiring Repairs Scan Tool Reference Control Module References Circuit/System Verification

  1. Ignition » On / Vehicle » In Service Mode
  2. Verify DTC is not set: ⇒ If the DTC sets Replace the component: K160 Brake System Control Module ⇓ If the DTC is not set
  3. All OK. Repair Instructions Perform the Diagnostic Repair Verification after completing the repair: Diagnostic Repair Verification For control module replacement, programming, and setup refer to: Control Module References