Skip to content
Tahoe / Yukon Service Manual

DTC B2AFB-B2AFE

Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provides an overview of each diagnostic category. DTC Descriptor DTC B2AFB Windshield Interior Service Temperature Sensor Circuit Low Voltage DTC B2AFC Windshield Interior Service Temperature Sensor Circuit High Voltage DTC B2AFE Windshield Interior Service Temperature Sensor Performance For symptom byte information, refer to Symptom Byte List. Circuit/System Description The windshield temperature sensor is part of a the B117 Windshield Outside Moisture/Ambient Light and Humidity Sensor that provides the BCM information about the passenger compartment side windshield temperature. A fused B+ circuit and ground is provided by the wiring harness. The sensor sends a LIN serial data message to the BCM. Conditions for Running the DTC System voltage = 9 – 16 V BCM is awake and communicating Conditions for Setting the DTC The body control module receives an improper status response indicating an internal fault in the sensor. Action Taken when the DTC Sets DTC Type C Conditions for Clearing the DTC DTC Type C Reference Information Schematic Reference HVAC Schematics Wiper/Washer Schematics Connector End View Reference Master Electrical Component List Description and Operation Automatic HVAC Description and Operation Electrical Information Reference Circuit Testing Connector Repairs Testing for Intermittent Conditions and Poor Connections Wiring Repairs DTC Type Reference Powertrain Diagnostic Trouble Code (DTC) Type Definitions Scan Tool Reference Control Module References for scan tool information Circuit/System Verification

  1. Ignition ON/ Vehicle in Service Mode
  2. Verify DTC B2AFB–B2AFE is not set. ⇒ If any of the DTCs are set Replace the B117 Windshield Outside Moisture/Ambient Light and Humidity Sensor. ⇓ If none of the DTCs are set
  3. All OK. Repair Instructions Perform the Diagnostic Repair Verification after completing the repair. HVAC Component Replacement Reference Control Module References for control module replacement, programming and setup