Skip to content
Tahoe / Yukon Service Manual

Brake Pad Life Monitoring Reset

The Brake Pad Life Monitoring Reset Learn is required after replacing the brake pads. The Brake Pad Life Monitoring Reset Learn procedure can be completed with a scan tool using the following steps:

  1. Install the scan tool to the data link connector.
  2. Ignition ON, engine OFF.
  3. Select the Front Axle Brake Pad Life Monitoring Reset or Rear Axle Brake Pad Life Monitoring Reset in the Brake System Control Module Configuration/Reset Functions list.
  4. Follow the scan tool directions to complete the reset procedure.
  5. Clear any DTCs that may be set.