On Off Vehicle Switch Replacement

On/Off Vehicle Switch Replacement Removal Procedure

On Off Vehicle Switch Replacement — figure 1

1. Using a flat-bladed plastic trim tool, release the retaining clips.
2. Instrument Panel Fuse Block Access Hole Cover (1) » Remove

On Off Vehicle Switch Replacement — figure 2

3. Using a flat-bladed plastic trim tool, release the retaining clips.
4. Instrument Panel Trim Plate Applique (1) » Remove

On Off Vehicle Switch Replacement — figure 3

5. Using a flat-bladed plastic trim tool, release the retaining clips.
6. Instrument Panel Center Trim Plate Applique (1) » Remove

On Off Vehicle Switch Replacement — figure 4

7. Instrument Panel Upper Trim Panel Bolt (1) » Remove [6x]
8. Using a flat-bladed plastic trim tool, release the retaining clips.
9. Disconnect the electrical connector.

Note

Use care not to bend or deform the thin area of the instrument panel trim pad.

10. Instrument Panel Trim Pad (2) » Remove

On Off Vehicle Switch Replacement — figure 5

11. Depress the retaining tabs on the on/off vehicle switch (1).

12. On/Off Vehicle Switch (1) » Remove Installation Procedure

13. On/Off Vehicle Switch (1) » Install

14. Connect the electrical connector.

15. Instrument Panel Trim Pad (2) » Install

Caution

Refer to Fastener Caution.

4. Instrument Panel Upper Trim Panel Bolt (1) » Install and tighten [6x] — Fastener Specifications

5. Instrument Panel Center Trim Plate Applique (1) » Install

6. Instrument Panel Trim Plate Applique (1) » Install

7. Instrument Panel Fuse Block Access Hole Cover (1) » Install