Skip to content
Tahoe / Yukon Service Manual

Automatic Transmission Fluid Cooling Heat Exchanger Inlet Hose Replacement

Automatic Transmission Fluid Cooling Heat Exchanger Inlet Hose Replacement (LM2 with MQC) Removal Procedure

  1. Drain the cooling system. Cooling System Draining and Filling
Automatic Transmission Fluid Cooling Heat Exchanger Inlet Hose Replacement — figure 1
Automatic Transmission Fluid Cooling Heat Exchanger Inlet Hose Replacement — figure 1

  1. Automatic Transmission Fluid Cooling Heat Exchanger Inlet Hose Clamp (1) » Disengage [2x] — Hose Clamp Replacement Guidelines - Spring Type

  2. Automatic Transmission Fluid Cooling Heat Exchanger Inlet Hose (2) » Remove Installation Procedure

  3. Automatic Transmission Fluid Cooling Heat Exchanger Inlet Hose (2) » Install

  4. Automatic Transmission Fluid Cooling Heat Exchanger Inlet Hose Clamp (1) » Engage [2x] — Hose Clamp Replacement Guidelines - Spring Type

  5. Fill the cooling system to the proper level. Cooling System Draining and Filling

  6. Start the engine and check for coolant leaks.