Skip to content
Tahoe / Yukon Service Manual

DTC C2A07

Diagnostic Instructions Perform the Diagnostic System Check prior to using this diagnostic procedure: Diagnostic System Check - Vehicle Review the description of Strategy Based Diagnosis: Strategy Based Diagnosis An overview of each diagnostic category can be found here: Diagnostic Procedure Instructions DTC Descriptor DTC C2A07 Engine Control Module Indicated Torque Signal Malfunction Symptom Byte Information: Symptom Byte List Circuit/System Description For an overview of the component/system, refer to: ABS Description and Operation Conditions for Running the DTC Ignition » On / Vehicle » In Service Mode Conditions for Setting the DTC Brake System Control Module = Malfunction Brakes Actions Taken When the DTC Sets Traction/Stability Control Indicator = ON Conditions for Clearing the DTC The conditions for setting the DTC no longer exist. A history DTC will clear after 40 consecutive malfunction-free ignition cycles. Reference Information Schematic Reference Antilock Brake System Schematics Connector End View Reference Master Electrical Component List Electrical Information Reference Circuit Testing Connector Repairs Testing for Intermittent Conditions and Poor Connections Wiring Repairs Scan Tool Reference Control Module References Circuit/System Verification

  1. Verify no other DTCs are set. ⇒ If any other DTCs are set Refer to: Diagnostic Trouble Code (DTC) List - Vehicle ⇓ If no other DTCs are set
  2. Replace the component: K20 Engine Control Module
  3. Verify the DTC does not set. ⇒ If the DTC sets Replace the component: K160 Brake System Control Module ⇓ If the DTC is not set
  4. All OK. Repair Instructions Perform the Diagnostic Repair Verification after completing the repair: Diagnostic Repair Verification For control module replacement, programming, and setup refer to: Control Module References