Skip to content
Tahoe / Yukon Service Manual

Rear Seat Back Cover and Pad Removal and Installation (40 Percent)

Rear Seat Back Cover and Pad Removal and Installation (40 Percent) Removal Procedure

Rear Seat Back Cover and Pad Removal and Installation (40 Percent) — figure 1
Rear Seat Back Cover and Pad Removal and Installation (40 Percent) — figure 1
  1. Reposition the rear seats as necessary.
  2. Using a suitable plastic trim tool, release the two rear seat anchor plate bezel plastic retainers.
  3. Rear Seat Anchor Plate Bezel (1) » Remove
Rear Seat Back Cover and Pad Removal and Installation (40 Percent) — figure 2
Rear Seat Back Cover and Pad Removal and Installation (40 Percent) — figure 2
  1. Disengage the J-channel retainers from the seat back cushion frame.
  2. Unzip the left and right rear seat back cover zippers.
  3. Reposition the rear seat back cover, pad, and retainers as necessary.
  4. Using a suitable flat-bladed tool, open the rear seat head restraint cable cover (1).
  5. Release the rear seat head restraint cable (2).
Rear Seat Back Cover and Pad Removal and Installation (40 Percent) — figure 3
Rear Seat Back Cover and Pad Removal and Installation (40 Percent) — figure 3
  1. Raise the rear seat head restraint to gain access to the rear seat head restraint guide bezels.
  2. Twist the rear seat head restraint guide bezels (1) counter clockwise while lifting the bezels upward onto the head restraint adjuster rod.
  3. Using a suitable pointed or flat bladed tool, push the rear seat head restraint guide clip (2)  rearward while pulling upward on the rear seat head restraint (3).
  4. Rear Seat Head Restraint (3) » Remove
Rear Seat Back Cover and Pad Removal and Installation (40 Percent) — figure 4
Rear Seat Back Cover and Pad Removal and Installation (40 Percent) — figure 4

  1. Remove the rear seat back cover and pad (1) as an assembly. Installation Procedure

  2. Install the rear seat back cover and pad (1) as an assembly.

  3. Rear Seat Head Restraint Guide Bezel (1) » Install [2x]

  4. Rear Seat Head Restraint (3) » Install

  1. Install the rear seat head restraint cable (2).

  2. Close the rear seat head restraint cable cover (1).

  3. Position the rear seat back cover, pad, and retainers to the original location.

  4. Zip the left and right rear seat back cover zippers.

  5. Connect the J-channel retainers.

  6. Rear Seat Anchor Plate Bezel (1) » Install

  7. Return the rear seats to their original positions.