Instrument Panel Trim Pad Replacement - Right Side

Removal Procedure

Instrument Panel Trim Pad Replacement - Right Side — figure 1

1. Using a flat-bladed plastic trim tool, release the retaining clips.
2. Instrument Panel Fuse Block Access Hole Cover (1) » Remove

Instrument Panel Trim Pad Replacement - Right Side — figure 2

3. Using a flat-bladed plastic trim tool, release the retaining clips.
4. Instrument Panel Trim Plate Applique (1) » Remove

Instrument Panel Trim Pad Replacement - Right Side — figure 3

5. Using a flat-bladed plastic trim tool, release the retaining clips.
6. Instrument Panel Center Trim Plate Applique (1) » Remove

Instrument Panel Trim Pad Replacement - Right Side — figure 4

7. Instrument Panel Upper Trim Panel Bolt (1) » Remove [6x]
8. Using a flat-bladed plastic trim tool, release the retaining clips.
9. Disconnect the electrical connector.

Note

Use care not to bend or deform the thin area of the instrument panel trim pad.

10. Instrument Panel Trim Pad (2) » Remove

11. Transfer components as necessary. Installation Procedure

12. Connect the electrical connector.

13. Instrument Panel Trim Pad (2) » Install

Caution

Refer to Fastener Caution.

3. Instrument Panel Upper Trim Panel Bolt (1) » Install and tighten [6x] — Fastener Specifications

4. Instrument Panel Center Trim Plate Applique (1) » Install

5. Instrument Panel Trim Plate Applique (1) » Install

6. Instrument Panel Fuse Block Access Hole Cover (1) » Install