Input Shaft Pilot Bearing Replacement

Special Tools DT-48212 Input Shaft Pilot Bearing Installer J-8092 Universal Driver Equivalent regional tools: Special Tools Removal Procedure

Input Shaft Pilot Bearing Replacement — figure 1

1. Using a suitable driver and an arbor press, remove the input shaft pilot bearing (1) by going through the front spline of the input gear. Installation Procedure

2. Install the bearing (1) using the small side of the DT-48212 bearing installer (2) and the J- 8092 Universal Driver (3) .

3. Press the bearing until the tool bottoms on the input shaft.