Front Side Door Outside Handle Replacement (with nwm)
- Disable the SIR system. SIR Disabling and Enabling
- Front Side Door Trim » Remove — Front Side Door Trim Removal and Installation

- Front Side Door Armrest Bracket Bolt (1) » Remove [2x]
- Front Side Door Pull Handle Bracket (2) » Remove

- Route front side door inside handle cable through hole in deflector (1).
- Front Side Door Water Deflector (1) » Remove

- Front Side Door Window Channel Retainer Bolt (1) » Remove [2x]

- Front Side Door Window Channel Retainer (1) » Remove

- Front Side Door Access Hole Plug (1) » Remove
- Front Side Door Lock Cover Bolt (2) » Remove

- Reposition the front side door weatherstrip to access the inboard lock cover bolt.
- Front Side Door Lock Cover Bolt (1) » Remove [2x]
- Front Side Door Lock Cover (2) » Remove

- Front Side Door Outside Handle Access Hole Plug (1) » Remove
- Pull the door handle to the open position then turn the front side door outside handle bracket rear bolt (2) counterclockwise until it clicks.

- Front Side Door Lock Cylinder Bezel (1) » Remove

- Disconnect the electrical connector. (1)

- Slide the front side door outside handle (1) rearward and then outwards in a swing motion releasing the rear part of the handle from the front side door outside handle bracket.

-
Swing the front part of the front side door outside handle (1) to remove. Installation Procedure
-
Install the front part of the front side door outside handle (1) into the front side door outside handle bracket.
-
Install the rear part of the front side door outside handle (1) into the front side door outside handle bracket and slide the front side door outside handle forward.
-
Connect the electrical connector. (1)
-
Front Side Door Lock Cylinder Bezel (1) » Install
-
Hold the front side door outside handle outwards in the open position.
- Front Side Door Outside Handle Bracket Rear Bolt (2) » Tighten — Fastener Specifications
- Test door handle for correct operation. If handle does not operate correctly, adjust front side door outside handle counterbalance.

Click Image For Video

Insert the EL-42059 (2) and grasp the counterbalance lever (1) . 9. Pull the EL-42059 (2) until the counterbalance lever (1) is fully rotated. Hold in this position. 10. Using a T25 Torx ™ driver (4), turn the front side door outside handle bracket rear bolt (3) counterclockwise until it clicks.

Click Image For Video
Front Side Door Outside Handle (2) » Install 12. Lightly press the front side door outside handle (2) to ensure it is in position. 13. Using a T25 Torx ™ driver (1), turn the front side door outside handle bracket rear bolt clockwise until the handle (2) is fully seated. 14. Front Side Door Outside Handle Bracket Rear Screw » Tighten — Fastener Specifications
-
Front Side Door Lock Cover (2) » Install
-
Front Side Door Lock Cover Bolt (1) » Install and tighten [2x] — Fastener Specifications
-
Install the front side door weatherstrip.
-
Front Side Door Lock Cover Bolt (2) » Install and tighten — Fastener Specifications
-
Front Side Door Access Hole Plug (1) » Install
-
Front Side Door Window Channel Retainer (1) » Install
-
Front Side Door Window Channel Retainer Bolt (1) » Install and tighten [2x] — Fastener Specifications
-
Route front side door inside handle cable through hole in deflector (1).
-
Front Side Door Water Deflector (1) » Install
-
Front Side Door Pull Handle Bracket (2) » Install
-
Front Side Door Armrest Bracket Bolt (1) » Install and tighten [2x] — Fastener Specifications
-
Front Side Door Trim » Install — Front Side Door Trim Removal and Installation
-
Enable the SIR System. SIR Disabling and Enabling