Emergency Vehicle Reading Lamp Replacement

Removal Procedure

Emergency Vehicle Reading Lamp Replacement — figure 1

1. Using a flat-bladed plastic trim tool, release the retaining clips.
2. Emergency Vehicle Reading Lamp Lens (1) » Remove

Emergency Vehicle Reading Lamp Replacement — figure 2

3. Emergency Vehicle Reading Lamp Bolt (1) » Loosen [2x]

4. Emergency Vehicle Reading Lamp (2) » Remove

5. Disconnect the electrical connector. Installation Procedure

6. Connect the electrical connector.

7. Emergency Vehicle Reading Lamp (2) » Install

Caution

Refer to Fastener Caution.

3. Emergency Vehicle Reading Lamp Bolt (1) » Install and tighten [2x] — Fastener Specifications

4. Emergency Vehicle Reading Lamp Lens (1) » Install