Wiring Systems and Power Management | Schematic and Routing Diagrams | Document ID: 2087480
Table 1:
Voltage Indicators
Table 2:
General Icons
Table 3:
Switch Position Icons
Table 4:
Module Circuit Function Icons
Table 5:
Harness Components
Table 6:
Component Parts
Table 7:
Switches and Relays
Table 8:
Devices and Sensors
Voltage Indicators
|
Symbol |
Description |
|
B+ |
Battery Voltage |
|
IGN 0 |
Ignition Switch– Off Position |
|
IGN I |
Ignition Switch– Accessory Position |
|
IGN II |
Ignition Switch– Run Position |
|
© 2023 General Mo |
tors. All rights reserved. |
| Symbol |
Description |
| IGN III |
Ignition Switch– Start Position |
General Icons
| Symbol |
Description |
| L O C |
Master Component List Icon This icon is used on the schematic to link to the Master Electrical Component List. |
| D E S C |
Description and Operation Icon This icon is used on the schematic to link to the Description and Operation of that particular system. |
|
Computer Programming Icon This icon is used on the schematic to link to Control Module References, which identifies which components need programming upon replacement. |
|
Next Schematic Page Icon This icon is used on the schematic to navigate to the next schematic in the subsystem. |
| Symbol |
Description |
|
Previous Schematic Page Icon This icon is used on the schematic to navigate to the previous schematic in the subsystem. |
|
Supplemental Inflatable Restraint (SIR) or Supplemental Restraint System (SRS) Icon This icon is used to alert the technician that the system contains SIR/SRS components that require certain precautions before servicing. |
|
Information Icon This icon is used to alert the technician that there is additional information that will aid in servicing a system. |
|
Danger Icon This icon is intended to alert the technician that a component within the system contains labeling with the same icon. This icon is used when a source component has potential for 60 volts DC or greater or has potential for 42 volts AC or greater. |
|
High Voltage Icon This icon is intended to alert the technician that a component within the system contains labeling with the same icon. This icon is used when a component/circuit has potential for 60 volts DC or greater or has potential for 42 volts AC or greater. |
| Symbol |
Description |
|
Caution Icon This icon is used to advise the technician to use caution when servicing this component. This icon may be used when a component/circuit has a voltage range potential between 30-60 volts DC or 15-42 volts AC. |
|
Functional Serial Data Communication This icon is used to show the technician that the serial data circuit detail is shown incomplete. It also provides an active link to the Data Communication Schematics were the circuit is shown complete. |
Switch Position Icons
| Symbol |
Description |
|
Generic Up Arrows |
|
Generic Down Arrows |
|
Generic Left Arrows |
| Symbol |
Description |
|
Generic Right Arrows |
|
Generic Express Down Arrows |
|
On/Off Icon |
|
Generic Lock Icon |
|
Generic Unlock Icon |
| Symbol |
Description |
|
Generic Window Switch Positions– 4 Door |
|
Generic Window Switch Positions– 2 Door |
Module Circuit Function Icons
| Symbol |
Description |
|
I/O Pull-Down Resistors (−) |
|
I/O Pull-Up Resistors (+) |
|
I/O High-Side Drive Switch (+) |
| Symbol |
Description |
|
I/O Low-Side Drive Switch (−) |
|
I/O Bidirectional Switch (+/−) |
|
Pulse-Width Modulation Symbol |
| B+ |
Battery Voltage |
| IGN |
Ignition Voltage |
| Symbol |
Description |
| 5V |
Voltage Reference |
| 5V AC |
A/C Voltage |
|
Low Reference |
|
Serial Data |
| Symbol |
Description |
|
Antenna Signal– In |
|
Antenna Signal– Out |
|
Brake Apply |
Harness Components
| Symbol |
Description |
| KR73 Ignition Main Relay |
Fuse Supplied by a Relay |
|
Circuit Breaker |
|
Fusible Link |
|
Case Ground |
| Symbol |
Description |
| Female Terminal X200 1 Male Terminal |
Inline Harness Connector |
| Male Terminal X200 1 Female Terminal |
Inline Harness Connector |
| X1 1 |
Pigtail Connection |
| X1 1 |
Pigtail Connection |
|
Provisional or Diagnostic Connector |
| Symbol |
Description |
|
Blunt Cut Wire |
| J200 |
Incomplete Physical Splice |
| J200 |
Complete Physical Splice– 2 Wires |
| J200 |
Complete Physical Splice– 3 or more wires |
|
Wire Crosses |
| Symbol |
Description |
| 9 |
Twisted Wires |
| A4 Hybrid/ Electric Vehicle Battery Pack Data Communication Schematics |
Circuit References |
| B A |
Circuit Continuation Arrowheads |
|
Option Breakpoint |
| Symbol |
Description |
|
Ground Circuit Connection |
|
Connector Shorting Clip |
Component Parts
|
Symbol |
Description |
|
|
Partial Component When a component is represented in a dashed box, the component or its wiring is not shown in its entirety. |
|
|
Entire Component When a component is represented in a solid box the component or its wiring is shown in its entirety. |
|
1 |
Connector Directly Attached to Component |
|
© 2023 General Mo |
tors. All rights reserved. |
| Symbol |
Description |
| X1 1 |
Pigtail Connector |
Switches and Relays
|
Symbol |
Description |
|
|
Accessory Power Outlet |
|
|
Cigar Lighter |
|
|
Switch– 2 Position Normally Open |
|
|
Switch– 2 Position Normally Closed |
|
© 2023 General Mo |
tors. All rights reserved. |
| Symbol |
Description |
|
Switch– Rocker |
|
Switch– Contact Plate (1 Wire) |
|
Switch– Contact Plate (2 Wire) |
|
Switch– 3 Position |
|
Switch– 4 Position |
| Symbol |
Description |
|
Switch– 5 Position |
|
Switch– 6 Position |
|
Switch Actuator– Push (Momentary) |
|
Switch Actuator– Push (Latching) |
|
Switch Actuator– Pull (Momentary) |
| Symbol |
Description |
|
Switch Actuator– Pull (Latching) |
|
Switch Actuator– Rotate (Momentary) |
|
Switch Actuator– Rotate (Latching) |
|
Switch Actuator– Slide (Momentary) |
|
Switch Actuator– Slide (Latching) |
| Symbol |
Description |
| P |
Switch Actuator– Pressure (Momentary) |
| T |
Switch Actuator– Temperature (Momentary) |
| L |
Switch Actuator– Volume (Latching) |
|
4-Pin Single Pole/Throw Relay– Normally Open |
|
5-Pin Relay– Normally Closed |
Devices and Sensors
| Symbol |
Description |
| + - - + |
Battery Assembly– Hybrid |
|
Single Filament Light Bulb |
|
Double Filament Light Bulb |
|
Light Emitting Diode (LED) |
| Symbol |
Description |
|
Photo Sensor |
|
Capacitor |
| Symbol |
Description |
|
Variable Resistor |
|
Variable Resistor– NTC |
|
Breakable Wire |
|
Heating Element |
|
Position Sensor |
| Symbol |
Description |
| P U |
Pressure Sensor |
|
Knock Sensor |
|
Inductive Type Sensor– 2-Wire |
|
Inductive Type Sensor– 3-Wire |
|
Hall Effect Sensor– 2-Wire |
| Symbol |
Description |
|
Hall Effect Sensor– 3-Wire |
|
Oxygen Sensor– 2-Wire |
|
Heated Oxygen Sensor– 4-Wire |
|
Solenoid– Actuator |
|
Solenoid– Valve |
| Symbol |
Description |
| M |
Motor with PTC |
Symbol
Description
Horn
Microphone
Airbag
SIR Coil
SIR Impact Sensor