DTC C059B or C0560

Diagnostic Instructions Perform the Diagnostic System Check prior to using this diagnostic procedure: Diagnostic System Check - Vehicle Review the description of Strategy Based Diagnosis: Strategy Based Diagnosis An overview of each diagnostic category can be found here: Diagnostic Procedure Instructions DTC Descriptor DTC C0560 Brake Master Cylinder Pressure Sensor 1 - Missing Calibration Symptom Byte Information: Symptom Byte List Circuit/System Description For an overview of the component/system, refer to: ABS Description and Operation Conditions for Running the DTC Ignition/Vehicle = ON Conditions for Setting the DTC Brake System Control Module = Missing Calibration Actions Taken When the DTC Sets Brake warning indicator malfunction. = ON ABS Warning Indicator = ON Traction/Stability Control Indicator = ON Hill Descent Control = ON Vehicle Speed Limit = Less than 100 km/h (62 MPH) Brake Assist = None Malfunction Indicator Lamp (MIL) = ON DTCs listed in the DTC Descriptor category = Type A DTC Conditions for Clearing the DTC DTCs listed in the DTC Descriptor category = = Type A DTC Reference Information Schematic Reference Antilock Brake System Schematics Connector End View Reference Master Electrical Component List Electrical Information Reference Circuit Testing C cu t est g Connector Repairs Testing for Intermittent Conditions and Poor Connections Wiring Repairs Scan Tool Reference Control Module References Circuit/System Verification

1. Ignition » On / Vehicle » In Service Mode
2. Perform the configuration/reset function: Brake Pressure Sensor Calibration
3. Verify DTC C0560 is not set. ⇒ If DTC C0560 is set Replace the component: K160 Brake System Control Module ⇓ If the DTC is not set
4. All OK. Repair Instructions Perform the Diagnostic Repair Verification after completing the repair: Diagnostic Repair Verification For control module replacement, programming, and setup refer to: Control Module References