Device Control Limits Exceeded Error

	Device Control Limits Exceeded Error Description	Corrective Action
	System Currently Active	Reason System has not exited active brake system during procedure. Action Taken 1. Ignition/Vehicle » Off — For greater than 5 s 2. Ignition » On / Vehicle » In Service Mode — For greater than 10 s 3. Ensure brake pedal is fully returned.
	Propulsion System Active	Reason Engine control Module indicating Propulsion is active Action Taken 1. Ignition/Vehicle » Off 2. Open and close the door. 3. Wait for greater than 2 min. 4. Ignition » On / Vehicle » In Service Mode
	Over temperature condition	Reason Brake System Control Module overheated Action Taken 1. Allow 20 min for Brake System Control Module to cool down.
	Wheel Speed Detected	Reason Any wheel speed sensor over 3kph (2mph) Action Taken 1. Wheel Speed Sensors should be 0 when vehicle is not moving. 2. Determine why Wheel Speed Sensor is greater than 0 when vehicle is not moving.
	ABS Solenoid Valves or Pump Motor Timer Exceeded	Reason Various tests have timed out Action Taken
	© 2023 General Mo	tors. All rights reserved.

	Device Control Limits Exceeded Error Description	Corrective Action
		1. Ignition/Vehicle » Off — For greater than 10 min 2. Ensure system is filled and bled adequately with no leaks 3. When performing learn procedures, follow the scan tool instructions
	Voltage Out Of Range	Reason Voltage at Brake System Control Module connector must be 8.5 – 16.8v Action Taken 1. Ignition/Vehicle » Off 2. Connect a battery charger to the battery.. 3. Inspect Brake System Control Module fuses and connector.
	Internal Malfunction	Reason 1. There is a DTC set 2. Learn procedures not completed 3. Hydraulic Operation has not been enabled Action Taken 1. If any DTC is set Refer to: Diagnostic Trouble Code (DTC) List - Vehicle
	Brake Pedal Applied	Reason Brake pedal applied Action Taken 1. Remove foot from brake and ensure pedal is returned 2. The Calculated Input Rod Position should not be greater than 0.3mm when brake pedal is returned. 3. Determine why brake pedal is not returning.
	Conditions Not Correct	Reason Brake Fluid Level Sensor was not disconnected Action Taken 1. Disconnect Brake Fluid Level Sensor connector. 2. The DTC “C0049 Low Brake Fluid Level
	© 2023 General Mo	Sensor Circuit Open“, will show if the tors. All rights reserved.

Device Control Limits Exceeded Error Description	Corrective Action
	Brake Fluid Level Sensor connector is disconnected.